ササミ's profile
Gender | Male |
---|---|
Experience | 6〜10 years |
User review
-
-
There is a feeling that it pops up on its own, so it is easy to lift the bottom rotation, and it is too high, so the tabletop is over if it is not really light.
The speed is normal, the spin is above and below the middle, there is a sense of stability, but over errors are careful.Overall Speed Spin Control Hardness Little hard
Recomend racket Innerforce Layer ALC
-
-
As expected, there is only thing that sits at the top of the sales ranking. Among the rubber of the same hardness zone, it is easy to use with Dantotsu.
It has the speed which exceeds the extent while securing the ball holding and the rotation amount necessary for the plastic ball.
Speaking of the weak point weak point is that the arch line is too high (this is the inside of the merit), it is easy to catch up, so it is somewhat susceptible to the influence of the opponent's rotation at the time of smashing.
Even junior high school students can reach the district upper level to the prefectural convention level and if there is enough power to wield the drive firmly it will not be a problem.
People who do not have much power should be 47.5 degrees as expected and should refrain from it.Overall Speed Spin Control Hardness Little hard
Recomend racket MA LIN EXTRA OFFENSIVE
-
-
First, isn't it a tension rubber? It seems. It seems to be important to control, but it is difficult to use it unless it jumps so far.
Even beginners are likely to stop using it after half a year. Ideal for sensory development.
It seems unlikely to use in the fore.Overall Speed Spin Control Hardness Soft
Recomend racket Innerforce Layer ALC
-
-
Mainly used in the back.
There is an emphasis on control, but the speed is surprising. The block is fast.
The drive to Tsuttsuki is fast and the feeling of use is close to the Fastark S-1. Even if you hit from a low point, the net will be over and it will be stable.
You can't expect anything that's out of rotation. To the last. I feel a little unsatisfactory, but if you are a small girl or elementary school student, I think it's fine.Overall Speed Spin Control Hardness Little soft
Recomend racket Innerforce Layer ALC
-
-
The sponge is softer but the seat is so stiff.
When sticking to a special material or seven plywood, the sponge will skip by the momentum of the racket and it will not catch the ball.
It is difficult to rub it if it is a racket of more than hard if it is 5 plywood to raise the lower rotation.
The speed is reasonable. It is not so good in the price range, but it is slow when looking at the whole rubber.
It is easy to use when it becomes a rally of upward rotation. From the sense of stability of the block meat 3rd ball For the back of beginners who do not use back drive.Overall Speed Spin Control Hardness Little hard
Recomend racket CLIPPER WOOD
Racket
Producer
Grip
Review Ranking
Rubber
Producer
Type
-
Get the Amazon gift card at a Review!
20 points are added in the post. You can replace it by Amazon Gift Card worth $5.00 with 1000 points.