土掘りマン's profile
Gender | Male |
---|---|
Age | U30 |
Experience | 11〜20 years |
User review
-
-
I'm using 2.0 as the back. After all it feels softer than 52.5 degrees. Is it about 48 degrees?
It's similar to the feel of the Tenergy 05, but it's supposed to swing, not an automatic rubber. Grab it from Tenergy at the time of impact. When I grab it, I feel "play" and "acceptance" as the word says. It is an image that even if the timing is slightly off, there is time to grasp by "play". Also, even if the rotation remains on the sphere, it is an image that will be erased with "acceptance".
Again, impact is important. I can get in by rubbing, but I can't get a good ball (I think I lack my skill ...).
The tabletop is pretty easy to do, and Chiquita is excellent.
Recommended for intermediate and above with a strong impact.Overall Speed Spin Control Hardness Little soft
Recomend racket ZX-GEAR OUT
-
-
It was an individual of 85g. It is a racket that is hard and has good ball separation, and it flies very much. Tension rubber (extra-thick) flies too much and cannot be used at my level.
However, it goes well with the 2.0 of the hybrid K3, and a ball that does not seem to be your own is released. I am very satisfied with both speed and rotation. Sufficient flight distance comes out even from the middle and apse.
I think that it is basically a racket for advanced users, but if the rubber is made thicker or less, I think that even intermediate users like me can handle it.Overall Speed Spin Control Touch Hardness Hard
-
-
I changed from the triple double extra that I had been using since its release.
If you can practice every day, it's a strong adhesive rubber, but since the practice time is limited, you can't speed up with a strong adhesive, so I tried using it.
The speed has increased unevenly while rotating the strong adhesive. Although it is a hard rubber, it is not ticky and the sheet is soft, so I was able to transition from strong adhesion without problems. I think that there is no problem if you are using adhesive rubber.
I don't feel much stickiness on the sheet, but the table and counter are sticky rubber itself. It can be said that it is the highest adhesive tension rubber.Overall Speed Spin Control Hardness Little hard
Recomend racket C-Hack
-
-
I hit 2.0. I didn't feel any stickiness, probably because I usually use adhesive rubber. Rotation takes more than tension rubber, and speed comes out from adhesive rubber.
It is also very easy to hit the bottom rotation. I will use it as a back rubber for a while.Overall Speed Spin Control Hardness Little hard
Recomend racket FORTINO PRO
-
-
Changed from Kenta Matsudaira ALC. First of all, I was surprised at how different the rubber was, even though I hadn't changed it.
The fore of the adhesive rubber had a high metallic sound, and the speech drive and counter became so fast that I couldn't think of it as my own ball. The loop drive floated or overrun until I got used to it.
The back is not as good as the fore, but it makes a good sound. Loop drive Chiquita is easy to hit.
The tabletop, blocks, and Tsuttsuki do not seem to have changed significantly.Overall Speed Spin Control Touch Hardness Little hard
Recommend rubber(Front) TRIPLE Double Extra
Recommend rubber(Back) V>11 EXTRA
Racket
Producer
Grip
Review Ranking
Rubber
Producer
Type
-
Get the Amazon gift card at a Review!
20 points are added in the post. You can replace it by Amazon Gift Card worth $5.00 with 1000 points.