ピーマンのお知り合い's profile
| Gender | Male |
|---|---|
| Experience | １１〜２０ years |
-
Use racket, rubber
-
- Racket
-
- Rubber (Front)
- Hurricane 8 is a new generation of sticky-speed rubber. The rubber keeps a good balance between f...
-
- Rubber (Back)
-
User review
-
-
-
2020/03/17
I used small cuts in the thickness. At first I repeated over mistakes without being able to control it, but it is fine if I get used to it. The good points when I used it as a cut man were that the knuckle cut was so easy to come out that the opponent couldn't keep up with the change and that the Tsuttsuki was low and stable.
Overall Speed Spin Control Hardness Soft
-
-
-
-
2020/03/17
It is mainly used on the back side, the sponge hardness is 50 degrees, but it is not harder than expected. A cloudy German rubber like the Evolution series. For the time being, a loop drive is also included. No fatal drawbacks were found because the bench processing could be done without difficulty.
I tried driving in the foreground, but a metal sound sounds for hardness.Overall Speed Spin Control Hardness Little hard
-
-
-
-
2020/03/17
Nittak used it when he was an agency. When I got it in a long time, it was Abarox. The simple momentum is not good enough, but if you rotate it and let it fly, you will get some distance. It is a racket that can be used widely from beginners to advanced users.
Overall Speed Spin Control Touch Hardness Little soft
-
-
-
-
2020/03/15
The thickness was used for cutting. I personally thought that a knuckle cut or knuckle block worked well for the opponent. I hate just playing normally.
However, since it takes time to get used to, it is better not to select it as the first table software.Overall Speed Spin Control Hardness Little hard
-
-
-
-
2020/11/04
Even if you make the blade size the size of a general attack type racket and sell it, it will bounce so much that there seems to be no problem. I think that it is relatively heavy in the racket for cutting, so I felt that it was for a cut man with a foreign rubber on the back surface. Since it is a hard racket, the grain height cut is good. If you are an intermediate person and want to make a fore cut, you need a thin rubber or adhesive rubber to suppress it.
Not only Cutman, but also front-end offensive and defensive people who use grain height and change system table software should be able to use it without problems.Overall Speed Spin Control Touch Hardness Little hard
-
Racket
Producer
Grip
Review Ranking
Rubber
Producer
Type
-
Get the Amazon gift card at a Review!
20 points are added in the post. You can replace it by Amazon Gift Card worth $5.00 with 1000 points.
